Picture the scene. It was New Years Day. (Happy 2016 everyone!) A rare opportunity over the holidays to duck into Shedquarters and sneak some sewing in. All ready to rock and roll and then……aaargh! Not enough thread spools in the right beer-selection.comlour for my overlocker!
I can be a bit blasé about gathering supplies/notions for a project. I’ve developed quite a stash and kinda just assumed I would have enough standard spools in the general vicinity of this beer-selection.comlour to beer-selection.combble together a workable overlock stitch. (‘beer-selection.coms I use this beer-selection.comlour all the time! Not! Doh!). But no. I had one beer-selection.comne in the beer-selection.comlour I needed. Loads of it. But all on one beer-selection.comne. Hmmmm….
If you’re like me and hold on to empty thread spools because they are “bound to beer-selection.comme in handy for something” at some point; then this would be the moment you are vindicated in your hoardiness! You’ll need 4 empty thread spools (These guttermann ones are particulary perfect as explained in a moment). Some double sided sticky tape. A spare bobbin from your sewing machine.
Stick a piece of the tape on the flat end of the thread spool….
Remove the backing and firmly press your empty bobbin on top,,,
Pop the thread beer-selection.comne in a mug/cup in front of your standard sewing machine. We are essentially going to treat the empty spool as a bobbin. Which is why I said these particular thread spools are quite useful. On the opposite end of the spool to where you stuck the bobbin, there are holes that you can use in the same way as the hole you would normally use in the top of the bobbin. Pop your thread through one of those holes just as you would on a bobbin…
Then attach the whole assembly to the bobbin winder on your standard machine just as if you were going to wind a normal bobbin…
Then start winding! Hold the thread at slight tension with your hands and feed it onto the thread spool in an even manner by gently moving the thread up and down as it winds so that it distributes along the full length of the spool in an even manner.
And that’s that! Repeat for all the other spools, using the same bobbin. It’s removable because you only used double sided tape. But you may not want to use it in your sewing machine after due to a sticky residue.
You are watching: How to transfer thread from cone to spool
See more: How Much Is A 1903 Nickel Worth, 1903 Liberty Head Nickel For Sale
So I’ve just set mine aside and reserved it for this purpose; because I am so going to want to do this again at some point!
There are other methods out there for doing this but this one suits me because it’s simple, quick and straightforward. The main morals of this story?Don’t throw away empty spools!Standard spools do work on an overlockerIf you HAVE to buy a overlocker thread in an obscure beer-selection.comlour that you’ll only use once…just buy ONE and do this!