Hey guys, what’s up. I just finished changing the engine oil in my car. So now I’m going to show you how to reset the oil life or oil change the required minder light on my Jeep Wrangler. When the light comes up, and it says, you know, oil change or whatever it is, I’ll show you how to get rid of that.
You are watching: How to reset oil change light jeep wrangler
It’s a little bit of a procedure, and it’s a little different than a lot of other vehicles in the sense that there’s a button that you press and kind of scroll through a few screens and stuff like that, but I’ll show you how to do it show you how to get past and reset it.
Jeep Wrangler Oil Life/Oil Change Required Light Reset GuideFor your info, this operation work for the Jeep Wrangler JL (2018, 2019, 2020, 2021 model years).
With Gas PedalThis is the quickest and most common way to reset oil life on all Jeep cars. So let’s going to reset the oil change indicator with these simple steps:
Turn the ignition keys to the RUN position or press the START button twice without turning the engineOnce you’ve done that, the lights will flash and you have 10 seconds in which time you need to step on the GAS pedal three timesOnce you have done that, you can remove your keys from the ignition and it should be reset
With Steering Button
Time needed: 3 minutes.In this section, I’m going to show you how to reset the oil life on a Jeep Wrangler by using the steering button. This is a 2019 model here but it will be the same in a few different years.
See more: The Opposite Of Lithification Is:, Transportationweatheringcompactioncementation
We need to turn the ignition to the RUN positionOn a push button Start ignition you need to press it two times, to make the ignition enter the run position and don’t actually start the engine thoughGo to the VEHICLE INFOOnce you have your ignition in the run position we’re going to use the buttons on the left-hand side of the steering wheel and we’re going to scroll down until we see the Vehicle Info screenFind the OIL LIFENext, you’re going to want to press the left or right button depending on which screen you’re on, and we’re going to scroll over until we get to the Oil Life screenPress and hold the OK buttonFinally, we’re going to press and hold down the ok button. That’s what’s going to reset it, so press and hold that downTurn the ignition off and start the engine to verify the indicator has been resetDone!
So there you have it simple straightforward but some people are just unaware of how to get it done. It would help if you were doing this when you’re changing the oil in your Jeep. So you can ensure that essentially that you are getting the proper counter for the next oil change. So you’re maintaining the appropriate maintenance of your Jeep Wrangler JL. Until next time, See you.