JavaScript is disabled. Because that a far better experience, please allow JavaScript in her browser before proceeding.


You are watching: Checking allison 1000 transmission fluid level

*

Hi all, ns am make the efforts to number out if I must add, remove or am simply right v my allisons fluid level. My tranny has been to run a bit warm since transforming the fluid, close come 200 compared to the normal 140/150 on warm days. I run my truck and have checked it at approximately 200 and it was at the high next of the warm band, I adjusted my outside filter and did not prefill it v fluid. Mine tranny then ran hotter after the change. I checked the level in ~ 160 and found it to be below the warm band. Now I just went external the check it cold and also the level was above the hot. I am at my wits end and connot figure out what to do. I feel choose my tranny is moving a bit oddly and was conviced that I had to tiny fluid, currently I am even an ext confused. I need help, please!!!
*

What you point out is odd yet found this post on what one need to be analysis at different temperatures. Http://www.beer-selection.com/forum/showthread.php?t=320087&highlight=correct+allison+levelBrian
*



See more: What Colors Can Leopard Geckos See Color? (Shocking Truth!) Can Leopard Geckos See In The Dark

(XXXXXX COLD XXXXXX)--------(XXXXXX warm XXXXXX)-----------------------------____________________________ ^______^________^ ____________________________160*___180*_____200*Automatic infection FluidWhen come Check and also Change(Pickup Models)A great time to examine your automatic transmission fluidlevel is when the engine oil is changed.Change both the fluid and filter every 25,000 miles(41 500 km) if the auto is mainly driven under oneor an ext of these conditions:• In hefty city traffic where the exterior temperatureregularly get 90°F (32°C) or higher.• In hilly or mountainous terrain.• once doing frequent trailer towing.• provides such as discovered in taxi, police ordelivery service.If you do not use your vehicle under any kind of ofthese conditions, readjust the fluid and filterevery 50,000 miles (83 000 km).How come CheckBecause this operation deserve to be a small difficult, you maychoose to have actually this done at the dealership servicedepartment.If you perform it yourself, be certain to follow all the instructionshere, or you can get a false analysis on the dipstick.Notice: Too lot or too tiny fluid can damage yourtransmission. As well much can mean that some of thefluid might come out and also fall on hot engine component orexhaust mechanism parts, beginning a fire. Too little fluidcould cause the infection to overheat. It is in sureto get an accurate reading if you check yourtransmission fluid.Wait at the very least 30 minutes prior to checking thetransmission fluid level if you have been driving:• When external temperatures are above 90°F (32°C).• at high speed for quite a while.• In heavy traffic — especially in warm weather.• while pulling a trailer.Checking the fluid LevelPrepare your auto as follows:• Park your car on a level place. Save theengine running.• v the parking brake applied, location the change leverin PARK (P).• through your foot ~ above the brake pedal, operation the enginefor at the very least one minute and shift to journey (D).Then shift to NEUTRAL (N) and then reverse (R)to fill the hydraulic system. Then, placed the shiftlever in PARK (P).• enable the engine to run at idle (500 – 800 rpm).Slowly release the brake pedal.Then, there is no shutting off the engine, follow this steps:Cold examine ProcedureThe purpose of the cold examine is to identify if thetransmission has sufficient fluid come be activate safely untila hot inspect can be made. The fluid level rises as fluidtemperature increases. Execute NOT fill over the COLDCHECK tape if the transmission fluid is below normaloperating temperatures.1. Pull out the dipstick and also wipe it through a clean rag orpaper towel. The transmission dipstick is locatednear the center of the engine compartment. SeeEngine Compartment overview on page 5-18 formore info on location.2. Push it back in all the way, wait three secs andthen traction it back out again.3. Examine the fluid level reading. Repeat the checkprocedure come verify the reading.4. If the fluid level is within the COLD examine band, thetransmission might be operated till the liquid is hotenough to do a warm check. If the liquid level is notwithin the COLD check band, include or drainpipe fluid asnecessary to lug the level into the center of theCOLD inspect band.5. Perform a hot check at the an initial opportunity after ~ thenormal operation temperature that 160°F (71°C) to200°F (93°C) is reached.6. If the liquid level is in the agree range, press thedipstick earlier in all the way.Hot inspect ProcedureThe fluid must be warm to ensure an accurate check.The fluid level rises as temperature increases.1. Run the infection in drive (D) till thenormal operating temperature that 160°F (71°C) to200°F (93°C) is reached.2. Pull the end the dipstick and wipe it with a clean rag orpaper towel.3. Press it ago in all the way, wait 3 secondsand climate pull it ago out again. Repeat the checkprocedure come verify the reading.4. Safe operating level is within the warm RUN bandon the dipstick. The broad of the hot RUN bandrepresents around 1.06 quart (1.0 liter)of fluid at regular operating temperature.5. If the liquid level is not within the hot RUN band,add or drain fluid as vital to lug the fluidlevel to in ~ the hot RUN band.6. If the fluid level is in the agree range, push thedipstick back in every the way.Consistency the ReadingsAlways check the fluid level at least twice utilizing theprocedures defined previously. Consistency(repeatable readings) is important to preserving properfluid level. If inconsistent readings persist, inspect thetransmission breather to be certain it is clean andunclogged. If readings room still inconsistent, contactyour dealer.How to include FluidRefer to the maintain Schedule to determine whatkind that transmission fluid to use. Check out RecommendedFluids and Lubricants on page 6-15.Add liquid only after check the transmission fluid whileit is hot. A cold inspect is supplied only as a reference. If thefluid level is low, add only sufficient of the ideal fluid tobring the level approximately the hot area for a hot check. Itdoesn’t take lot fluid, generally less than one pint(0.5 L). Don’t overfill.Notice: usage of the incorrect automatic transmissionfluid may damage your vehicle, and the damages maynot be covered by her warranty. Always use theautomatic infection fluid provided in RecommendedFluids and Lubricants on page 6-15.• After adding fluid, recheck the fluid level together describedunder “How come Check.”• when the correct fluid level is obtained, press thedipstick back in all the way.