This overview shows how to change the main VSS sensor ~ above Nissan equipped v the 3.5L V6 engine and CVT transmission. Note that your Nissan may have a secondary VSS sensor that is bring about the problem.

The transmission rate sensor top top Nissan CVT automatically transmission might fail, leading to shiftingtransmission may fail, resulting in shifting problems. 


It can reason hard shifting, check engine light, or a bang as soon as you move the shifter from Park to drive or Reengine light, or a bang once you relocate the shifter native Park to journey or turning back gears.

You are watching: 2007 nissan murano transmission speed sensor location

This infection is installed on multiple cars, consisting of Nissan Altima, Cube, Juke, Maxima, Murano, NV Cargo, Pathfinder, and also Quest.

Symptoms

Symptoms of bad transmission rate sensor

Harsh shiftingPossibly associated Fault Codes

What friend need

10mm socket, extension, and ratchet.4" Extension

Procedure

There room two methods to replace the rate sensor top top Nissan CVT transmission.

This an initial requires removing the battery and also the starter, which will take a lot of time.

The second is to accessibility the speed sensor from the bottom that the engine. The sensor is top top the next of the infection housing facing the front. It is on the exact same side as the starter. 

Remove the plastic splash shield indigenous the bottom that the engine.Disconnect the electric connector. Use a flat screwdriver to pry the plug away from the sensor.
*
Remove the 10mm bolt. Get it loosened using her 10mm socket and ratchet. Next, remove the bolt through hand.
*
Remove the old speed sensor from the transmission housing. There may be a tiny amount of oil leaking from the sensor hole.
*
Tighten the 10mm bolt. Attach the electric connector. 
*
Lower the vehicle and follow the suitable procedure to check the automatic transmission transmission liquid level.

If the check engine irradiate is on, plug an OBD2 scanner right into the diagnostic port under the dashboard (driver"s side) come read and also clear any kind of stored faengine light is on, plug an OBD2 scanner into the diagnostic harbor under the dashboard (driver"s side) come read and also clear any kind of stored error codes. 


Notes

The sensor is right below the starter. If you room accessing the sensor from underneath the vehicle, making use of a 1/4" ratchet and 4" expansion is better to acquire to the 10 mm bolt.

Input speed Sensor Location

On Nissan vehicles equipped with the CVT transmission, the input speed sensor is located on the side of the transmission housing.

See more: Brangus Cattle Pros And Cons Of Brahman Cattle, Brahman Cattle By Lindsay Bowman

How come diagnose Nissan transmission speed sensor

A mechanic will connect an OBD-II transmission scanner that deserve to read Nissan codes. 

Locate the OBD2 harbor under the dashboard.Turn the ignition to place II. All dash lights will revolve on.Allow the scanner to strength on.Select review codes.Verify that fault codes room pointing to a faulty transmission rate sensor.